12
Getting Started
Rear
N
[MONITOR OUT] Monitor Video Signal
Output Terminal (RCA)
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75 K).
Use this terminal to connect to devices such as a
video monitor.
This terminal is used for adjusting the camera
angle during installation. (A Page 19)
Memo:
● Use the J [MONITOR OUT]switch to select
the availability of output as well as the signal
system. When the switch is toggled, press
the K Reset button for less than two seconds
to reboot the unit.
● When using the [MONITOR OUT] output, set
the privacy mask to AOffB. (A Page 61)
O [10BASE-T/100BASE-TX]
Use this terminal to connect to the network via a
LAN cable.
This product supports PoE (IEEE802.3af) and
therefore can be used without a power cable.
PoE: class 0
(A Page 17,18)
P [ALARM INPUT/OUTPUT] Alarm Input/
Output Terminals
Use these terminals to connect to an external
alarm device.
(A Page 20)
Q [AC24V] Power Input Terminal
Use this terminal to connect to an AC 24 V,
50/60 Hz power supply.
(A Page 17)
R Fall Prevention Wire Mounting Screw
(M3 x 6 mm)
Use this screw to mount the fall prevention wire.
(
A
Page 21)
S [AUDIO IN/OUT] Audio Signal Input/
Output Terminal(Mini jack, R 3.5, stereo)
This is an audio input/out terminal. Connect
using a mini jack R3.5 stereo cable.
(A Page 19)
Name and Function of Parts
(continued)
N
O
R
