58
Setting Using Internet Explorer
PTZ Page
Set the movement for AAuto ReturnB, AZoom LimitB and APreset PositionB.
This page can be used during access using AadminB or AoperatorB..
● First of all, configure the encoding settings.(A Page 39)
● Click [Advanced Settings] to display setting menu.
● Click [PTZ].
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
Note:
● This feature can be used when the distribution size pattern setting on the Encoding page is set to A
(MPEG4 only), C (MPEG4 only), D (JPEG only), F, or H. (A Page 39)
Setting (continued)
Click
A Auto Return Restores automatically to the state specified under [Mode] when action is
not performed on the manually operated camera over the interval specified
in [Return Time].
Mode For setting the action after Auto Return.
None : Auto Return disabled.
HOME : Returns to the home position.
Auto Patrol: Restores the auto patrol action.
Return Time For setting the time interval before restoring the action via Auto return.
[Set values: 1 minutes, 2 minutes, 3 minutes, 5 minutes, 10 minutes,
20 minutes, 30 minutes, 60 minutes]
Test
Click [Execute] to perform a test execution of the preset Auto Return action.
B Limit
Zoom Limit Set maximum value of electronic zoom feature.
[Set values: 1 , 2 , 4 , 8 ]
C Preset Position
Speed
For adjusting the speed of movement to the Preset Position.
This is also applicable to movement to the Preset Position in the Auto Patrol
mode.
Speed [Set values:Moment, Low, Mid, High]
