A SERVICE OF

logo

Open as PDF
next previous
40 Chapter 3. TV Setup
IEEE 1394 Connections
TheNew1394Devicescreenappearsifyouconnected
anIEEE1394device.Seefigure7.IEEE1394devicesare
automaticallyunderNetCommandcontrol.TheTVcan
recognizeuptosevenIEEE1394devicesatonetime.If
youconnectmorethanonedeviceofthesametype,a
uniqueidentifierisaddedtothenameforeachone.For
example,ifyouconnectthreeA/Vdiscs,youmayseeAV
Disc, AV Disc1, AV Disc2.
Figure 7. The New 1394 Device screen shows the device
name and includes a check box for an associated analog
connection.
IEEE 1394 Device with an Analog Connection
SomeIEEE1394deviceshavebothdigitalandanalog
outputstotheTV.Ifyouhavesuchadevice,placea
checkmarkintheAnalog Connectioncheckboxtoallow
youtousetheTV’sInputSelectionmenutoselecteither
theanalogordigitaloutput.
When You First Connect a Device
,
continued
Forinstructionsonswitchingbetweenanaloganddigital
outputs,seechapter6,“NetCommandOperations.”
IfyourIEEE1394devicecanbeconnectedtotheTVwith
ananalogconnection,followtheinstructionsbelow.
1. ConnectthedevicetotheTVwith an IEEE 1394
cable first.
2. WhentheNew1394Devicescreenappearswiththe
Analog Connectioncheckboxhighlighted,press
ENTER
toenteracheckmark.
3. IntheNew1394Devicescreen,notethename
assignedtothedevice,asyouwillneedtousethe
samenameinalaterstep.Seefigure7,New1394
Devicescreen.
4. ConnectthedevicetotheTVwiththesupplemental
analogcable.
5. ThenextscreenistheautoInputSensingscreen
(seefigure6)inwhichyoucanselectanameforthe
device.Ifyouselectthewrongnameforthedevice,
youwillbeunabletoswitchbetweentheanalogand
digitalinputstotheTV.
Ifthedeviceisacablebox,selectthenameCABLE
asthenamefortheanaloginput.
Note: Ifyouconnectedthecablesinreversesequence
(analogrst),youwilllaterneedtochangethe
inputnameintheInputNamemenu.
a. Switchtoanyviewingdeviceotherthanthe
oneyouwishtochange(press
INPUT
toopen
theInputSelectionmenu).
b. OpentheNetCommandmenuandthenopen
theInputNamemenu.
c. Highlightthetextboxfortheanaloginput
usedfortheIEEE1394device.
d. Press toscrollthroughtheavailable
namestodisplaythenameyouearliernoted
fortheIEEE1394device.
e. Press
EXIT
.