A SERVICE OF

logo

5 - 5
No. 99MBC095A
5. MEASUREMENT MODE
5)
LOCK/
UNIT
key
PROG
This key is used to enter the modification mode of the unit of
measurement. If the metric unit is currently being used,
will be flashing; and if the E unit is currently being used,
will be flashing.
If the
ENT
key is pressed, the unit is changed to that which is currently flashing, then
operation returns to the ready state.
If the
LOCK/
UNIT
key or
SET
key is pressed halfway in the setup operation, the setup
operation is aborted, and operation returns to the ready state.
The metric to E (1 E = 25.4 mm) conversion table is shown below.