A SERVICE OF

logo

3 - 15
No. 99MBC095A
3. DISPLAYS AND KEY OPERATIONS
IMPORTANT 1. For measuring ultra fine wire with a diameter thinner than that of the laser beam,
the SHL (signal level for detecting a workpiece) needs to be changed according to
the workpiece size (external diameter).
2. Since the SHL is changed to the level most appropriate for the workpiece size,
multiple workpieces or workpiece fixtures existing within the laser scanning range
may disable the detection of a workpiece less than 0.05 mm in diameter. Exercise
care so as not to produce multiple shadows within the scanning range.
3. Also, if the segment is set to 1 or 3, it is not possible to determine the position of
a fine workpiece less than 0.05 mm in diameter, runout, and bending.