127
[Screenshot 4]
A screen on which you can select a hard disk (unit)
appears.
<Screen at RAID function activated>
m Press the arrows button (A, B, C and D) to move the
cursor to the hard disk (unit) to be initialized and press
the [SET] button.
[Screenshot 5]
A screen on which you can select a method of capacity set-
ting for recording area appears.
<Screen at RAID function activated>
, Press the arrows button (A and B) to select a method
of record area setting from among the following and
press the [SET] button.
Auto Setup: Assigns each record area at the same
ratio as the existing hard disks. (→ to step 9)
All Copy Area: Sets the whole selected hard disk (unit)
to a copy area. (→ to step 9)
All Pre REC Area: Sets the whole selected hard disk
(unit) to a pre-record area. (→ to step 10)
Detailed Setup: Sets each record area individually. (→
to step 11)
Important:
If the hard disk of this unit is selected, "All Pre REC
Area" is not selectable.
[Screenshot 6]
The setting screen of each record area appears.
<Screen at "Auto Setup" selected>
<Screen at "All Pre REC Area" selected>
. Confirm the capacity of each record area and press the
[SET] button.
→ The format check screen appears.
(→ to step 13)
