128
[Screenshot 7]
The setting screen of pre-record area appears.
⁄0 Press the arrows button (A, B, C and D) to select
camera CH for pre-recording and rotate the jog dial to
decide the capacity of selected pre-record area.
For deciding the capacity of pre-recording with two or
more camera CHs, repeat this procedure.
Press the [SET] button after setting.
→ The format check screen appears. (→ to step 13)
Important:
The camera CH that was already assigned to a pre-
record area with a different hard disk (unit) is not selec-
table.
[Screenshot 8]
The setting screen of record area appears.
⁄1 Press the arrows button (A and B) to select a record-
ing area and rotate the jog dial to decide the capacity
of selected recording area.
For deciding the capacity of two or more recording
areas, repeat this procedure.
⁄2 Press the [SET] button after setting.
[Screenshot 9]
The format check screen appears.
⁄3 Press the arrows button (A and B) to move the cursor
to "EXECUTE" and press the [SET] button.
→ Formatting starts and the top page of the disk config-
uration menu resumes.
