A SERVICE OF

logo

Open as PDF
next previous
6. At the Port 1-VLAN Port configuration page, select VLAN 2 and VLAN 3 to add to the Port 1. The right
information window at this table shows the status. The screen in Figure 7-4 appears.
Figure 7-4 Assign Port-1 to be VLAN 2 and VLAN 3 member.
7. After the down the Port 1 VLAN configuration, press “close” to back to the 802.1Q VLAN main screen. And
check if the setting be applied to Port 1 at the “Egress Policy” column. The screen in Figure 7-5 appears.
Figure 7-5 Port 1 VLA N status
8. Assign the VLAN 2 and VLAN 3 group member. At this case, Port 2 had been assigned to as VLAN 2 group
member and Port 3 be assigned to as VLAN 3 group member.
9. Repeat step 2 to step 7, expect that :
• Configure the Port 2 with PVID=2, Port 3 with PVID=3.
• The link type of both Port-2 and Port 3 are “Always Untag”.