36
ENGLISH
Repeat the above steps to to
memorize other stations.
4
After selecting the tuner as an input
source, select the preset tuning mode.
1
Listening to FM stereo broadcasts
• The station has now been stored in the memory.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If “MEM” goes off, start again from the above
step .
• Then “PRESET” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
• While listening to FM broadcasts.
• Each time this button is pressed, the FM mode changes
as follows;
Stereo mode : “ST” lights up.
Mono mode : “ST” goes off.
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
Scanning preset stations in sequence
• The receiver will start scanning the stations in the preset
sequence and each station is received for 5 seconds.
• At the desired station, press this button again to stop
scanning.
• When pressing the PRESET +/- buttons on the remote
control, you need not select the preset tuning mode on
step .
Tuning to preset stations
Select the desired preset number.
2
Select the desired preset number (1~30) and
press the MEMORY/ENTER button.
3
