133
5
6
Enter the values read in step 5 for the specified area, and then press
the [SET] button. Set 4 values in order.
• After the setting of 4 values is finished, the next edit area menu is displayed. Repeat steps 5 and 6 when you
specify other areas. Up to 4 areas can be specified on an original.
• To correct the value which has been set, press the [RESET] button. Pressing it once makes the highlighted
field move one position upward. Highlight the field in which you want to rectify the value, and then key in the
correct one.
• If the [RESET] button is pressed while the X1 field is highlighted, all values in the fields will become “0”.
7
Press the [ENTER] button after specifying the area.
9
Press the [START] button.
8
Place the original(s) with its face down.
• Set the original face down with its bottom toward you and fit its
top left corner against the top left corner of the original glass.
• Select other copy modes as required.
