VX-8R OPERATING MANUAL 157
SET MODE ITEM 91: SPEC-ANALYZER
Function: Selects the Spectrum Analyzer sweep mode.
Available Values: 1Time / CONTINUOUS / Full Time
Default: 1time
1Time: The receiver sweeps the current band once.
CONTINUOUS: The receiver sweeps the current band repeatedly until the Spectrum Ana-
lyzer is turned off.
Full Time: This mode is activated similar to a “Continuous” mode. However, the
transceiver outputs audio on the center frequency (T) through the speaker
when Spectrum Analyzer is activated.
SET MODE ITEM 92: SQL LEVEL
Function: Sets the Squelch threshold level.
Available Values: LEVEL 0 ~ LEVEL 15 (AM and Narrow FM), LEVEL 0 ~ LEVEL 15
(Wide FM and AM Broadcast)
Default: LEVEL 1 (AM and Narrow FM), LEVEL 2 (Wide FM and AM Broadcast)
SET MODE ITEM 93: SQL S-METER
Function: Adjusts the Squelch threshold level to the S-meter level.
Available Values: OFF / LEVEL 1 ~ LEVEL 9
Default: OFF
SET MODE ITEM 94: SQL SPLIT
Function: Enables/Disables split CTCSS/DCS coding.
Available Values: OFF / ON
Default: OFF
When this Set Mode Item is set to “ON”, you can see the following additional parameters
after the “MESSAGE” parameter while selecting the Set Mode Item 97: SQL TYPE:
D CD: DCS Encode only (“DC” icon will appear while operating)
TONE-DCS: Encodes a CTCSS Tone and Decodes a DCS code
(the “T-D” icon will appear during operation)
D CD-TONE SQL: Encodes a DCS code and Decodes a CTCSS Tone
(the “D-T” icon will appear during operation)
Select the desired operating mode from the selections shown above.
SET MODE
SET MODE SELECTION DETAILS
