Filter
Top Products
Configuring the Primary Boot Source 15
4 At the Enterprise OS prompt, enter:
SysconF 2
The Primary Boot Source menu is displayed:
5 Enter 1 to select a boot filename.
Information similar to the following is displayed:
Current Boot Filename: a:/primary/boot.29k
Enter Boot Filename (CR = no change):
6 Enter a new boot filename (such as b:/primary/boot.29k) and press the Return key.
The configuration files must reside on the same drive as the boot source. If the
drive you specify is different from the configuration boot source drive, you are
prompted to change the configuration file source to the same drive.
If the boot drive you specify conflicts with the one set in the Dump Destination
parameter, you are prompted for a different drive.
7 Enter q to quit the menu.
The System Configuration menu showing the new entries is displayed:
8 Enter q to quit the configuration program.
9 At the prompt, enter:
ReBoot
The NETBuilder II bridge/router reboots using the newly established drive B as the
primary boot source.
For drive B to function as the boot source, a flash memory card with software
version 11.3 must be installed in drive B.
Primary Boot Source:
1. Boot Filename: a:/primary/boot.29k
2. Config File Source a:/primary
3. IP Addresses Client:none Subnet Mask:none
4. FTP Login Parameters
Enter parameter number or press Q to quit:
System Configuration
1. Serial Ports Console: 9600
2. Primary Boot Source b:/primary/boot.29k, b:/
3. Secondary Boot Source b:/secondar/boot.29k, b:/
4. Test Boot Source a:/primary/boot.29k, a:/:
5. Boot Sources Primary and Secondary
6. Dump Destination Partial dump only
7. Recovery Procedure
8. MP Boot Source
9. Boot Statistics Booted: 1 Exceptions: 0
Enter parameter number or press Q to quit: