Filter
Top Products
1-28
C
H
A
P
T
E
R
1:
G
E
T
T
I
N
G
S
T
A
R
T
E
D
IP Address of this end of the ISDN link
By default
this field is set to
UNNUMBERED
which allows
unnumbered links to be used. This options is suitable
for most network configurations. See
Appendix A
for
more information about numbered and unnumbered
links.
If you want to use numbered links, you must enter
an IP address for this port that is on a different
network or subnetwork than the unit’s IP address.
If you are routing IPX using PPP, you must use
numbered links.
IP Address at the other end of the ISDN link
By
default this field is set to
UNNUMBERED
indicating
unnumbered links are being used. If you are using
numbered links, type the IP address of the remote
ISDN port on the unit to which you want to connect.
It must be on the same network or subnetwork as
the local ISDN port.
IP Mask of the ISDN Link
If you are using
unnumbered links, leave this field set to 0.0.0.0. If you
are using numbered links, type a subnet mask
suitable use with the IP addresses you have selected
for the ISDN ports at both ends of the link. See
Appendix A
for more information about subnet masks.
IP Address of the Remote Host
Type the IP address
of a host on the remote network to which you want
to connect.
IP Mask of the remote host’s network
Type an IP
subnet mask to filter connections to inappropriate
hosts. See
Appendix A
for more information about
subnet masks.
Make of remote router
This option sets PPP
parameters needed to connect to the remote unit in
its default configuration. If the remote unit’s PPP
configuration has been altered, you will need to
amend the PPP parameters on this unit to reflect the
changes. Refer to the
Software Reference
guide for
more information
Toggle this field to the type of remote router to
which you are connecting. The PPP options for the
default settings at the remote router are then
automatically configured when you press [CTRL]+[E]
to exit this screen. The options are:
■
Default – Use this option if you are connecting to
another OfficeConnect Remote. Also use this
option if the remote unit is none of the following
and amend the PPP parameters accordingly.
Rc.bk : RC01.FRM Page 28 Thursday, July 10, 1997 9:53 AM