Filter
Top Products
42 78-9000-0192-2 Rev C
13. Locating 3M
™
Electronic Markers and 3M
™
iD
Markers
(3M
™
Dynatel
™
Models 2550-iD and 2573-iD only)
A. Enabling/Disabling Marker Types
Menu/OK [5:Toggle to MAIN MENU] + >>More [SK:4] + [SK:5] + >>More [SK:d] + >>More
[SK:h] + MarkerType [SK:j]
The unit will default with all markers enabled ().
Step 1. Press the up/down arrows [SK] to highlight
a utility to enable or disable.
Step 2. Press Enabl/Disabl [SK].
− Only the markers that are enabled ()
will be available in the locate mode.
Step 3. Press Menu/OK [5] to save settings or
Exit [SK] to cancel.
B. Alert Mode
While tracing a cable or pipe, it is possible to search for iD markers.
Step 1. Press Alert [SK].
− If the unit is in Dir Pk, DirNull, Ind
Pk or T-View modes, a prompt will
notify the operator that alert mode only
functions in Special Peak (Spl Pk) mode.
Step 2. Press Mode [SK Toggle] for Spl Pk.
Step 3. Press Alert On [SK Toggle].
− The receiver display will add the Alert
bar graph and the type of marker to
the display with a prompt to adjust the
marker gain. (Note: The marker utility
type will default to the last utility type of
marker selected in Marker Locate mode.
To change the utility type of marker to
locate see Step 6 below.)
Step 4. Press the Gain [3] until only a small mark
on the marker bar graph is visible.
Step 5. Press Menu/OK [5] to save the marker gain
setting.