Filter
Top Products
78-9000-0192-2 Rev C 45
Step 3. To save the depth reading, press Mem
Select [SK].
− Five depth readings can be saved with
the time, date, and its identification
(serial) number.
− Save [SK] will place each entry in
sequential order in memory (M1 - M5)
until five readings have been stored.
The receiver will overwrite saved
entries in excess of five, beginning with
M1.
Step 4. Optional step: Press Clear All [SK] to delete all stored depth information.
Step 5. Press Mem Select [SK] to select a specific memory location (M1 - M5) to store
the depth readings. When the preferred location appears on the display, press
Save [SK]. The display and memory location will populate with the current
information.
Step 6. Each memory location can be reviewed by pressing Mem Select [SK].
Step 7. Press Menu/OK [5] to return to Marker Locate Mode.
F. Passive Electronic Marker (Non-iD) Depth
Step 1. Lower the tip of the receiver to the ground over the pinpointed marker.
Step 2. Press DEPTH [4].
− The receiver will examine the pinpointed marker.
− The display will instruct the operator to raise the unit 6 inches (15.2 cm)
from the ground.
Note: This 6-inch (15.2 cm) rise must be exact for the depth reading to be accurate.
A suggestion is to utilize a 6 inch (15.2 cm) piece of plastic pipe or wood as a spacer
between the ground and the tip of the receiver for this precise measurement.
Step 3. Raise the receiver 6 inches (15.2 cm). Press
the DEPTH [4] key again. The estimated
depth of the marker from ground level will
be displayed.
− Five depth readings can be saved with
the time and date.