Filter
Top Products
20
To listen, choose Perform (this de-activates the click). You can drop in and out of these two
modes as you record. While the SR-16 is in either mode, you can change Pattern
quantization, swing, click rhythm and volume, pad velocity response, name, drumset, drumset
parameters, and MIDI parameters. You can therefore keep the groove going at all times, even
while you make adjustments prior to recording another part.
NOTE: Compose mode cannot be selected when using Preset Patterns, since they
cannot be altered. If you wish to alter one of the Preset Patterns, copy it to
an empty User Pattern first. (see section 3.3A)
3.1C Set Pattern Tempo
The tempo range extends from 20 to 255 beats per minute. Tempo can be changed while the
SR-16 is stopped or running. There are two ways to set tempo.
• Before initiating Pattern play, tap the STOP button several times at the desired tempo. The
SR-16 will average the time between taps and derive a tempo; the display will update the
tempo with each tap. If a footswitch is plugged into the Count/A/B/Fill jack, tapping the
footswitch at the desired rate is equivalent to tapping the STOP button. These techniques
work only if the SR-16 is stopped.
• Use the TEMPO/PAGE up and down buttons. Press once to increment/decrement 1 BPM at
a time, or press and hold to scroll through the tempo values.
Background While in Pattern mode, the tempo remains as is until changed because the tempo is a global
setting—it is not stored with individual Patterns. If you switch over to Song mode (Chapter 5) and the programmed
Song tempo is different, the SR-16 will assume the Song's tempo—even if you switch back into Pattern mode—
until the tempo is changed again (either manually, or by selecting a different Song).
3.1D Select Individual Patterns
1. Make sure the SR-16 is in Pattern mode.
2. Enter a two-digit Pattern number (remember to enter a leading 0 if necessary).
3. Press the A button to select the A Main Pattern, or B to select the B Main Pattern. To select
a Fill Pattern, first select the desired Main Pattern (A or B) then press the Fill Button.
4. Press PRESET/USER to select either a Preset or User Pattern.
When a Main Pattern reaches its end, it will loop back to the beginning and continue playing
from that point unless you select a new Pattern, selected a Fill Pattern initially, or stop the
Pattern (section 3.1E).
If you select a User Pattern that contains no data, the display says EMPTY PATTERN. If you
select a User Pattern that contains data but has not yet been named, the display says NO
NAME.
3.1E Stop/Restart a Pattern
1. To stop the Pattern, press STOP.
2. To restart the Pattern from the beginning, press PLAY. Pressing PLAY will always restart a
Pattern from the beginning, regardless of whether the Pattern is stopped or already playing.