Filter
Top Products
19-EN
Bit rate
This is the “sound” compression rate specified for encoding. The
higher the bit rate, the higher the sound quality, but also the larger
the files.
Sampling rate
This value shows how many times per second the data is sampled
(recorded). For example, music CDs use a sampling rate of 44.1 kHz,
so the sound is sampled (recorded) 44,100 times per second. The
higher the sampling rate, the higher the sound quality, but also the
larger the volume of data.
Encoding
Converting music CDs, WAVE (AIFF) files, and other sound files into
the specified audio compression format.
Tag
Song information such as track titles, artist names, album names,
etc., written into MP3/WMA/AAC files.
Root folder
The root folder is found at the top of the file system. The root folder
contains all folders and files.
iDA-X200
iDA-X300
Adjusting Subwoofer/Bass/Treble/
Balance (Between Left and Right)/Fader
(Between Front and Rear)/Loudness/
Defeat
1
Press IMPRINT (iDA-X200 only) or SOUND (iDA-
X300 only) repeatedly to choose the desired mode.
Each press changes the mode as follows:
SUBW LV*
1
BASS LV TREBLE LV BALANCE LV
FADER LV*
2
LOUD*
3
DEFEAT VOLUME
SUBW LV*
1
Subwoofer: 0 ~ 15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance: –15 ~ +15
Fader: –15 ~ +15
Loudness : ON/OFF
Defeat : ON/OFF
Volume: 0 ~ 35
• If IMPRINT (iDA-X200 only) or SOUND (iDA-X300 only) is not
pressed within 5 seconds after selecting the Subwoofer, Bass, Treble,
Balance or Fader mode, the unit automatically returns to normal
mode.
• Loudness introduces a special low-and high-frequency emphasis at
low listening levels. This compensates for the ear’s decreased
sensitivity to bass and treble sound. The function is inoperable when
DEFEAT is set to ON.
*
1
When the subwoofer mode is set to OFF, its level cannot be adjusted.
*
2
If you set the 4.2ch (FRONT/REAR/SUBW.)/2.2ch (3WAY) switch of
the IMPRINT audio processor (PXA-H100) to 2.2ch (3WAY), you
cannot adjust the FADER mode. For details, refer to the Owner’s
Manual of PXA-H100.
*
3
When an external audio processor is connected, this setting cannot
be made.
2
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) until the
desired sound is obtained in each mode.
• Depending on the connected devices, some functions and display
indications do not work.
Terminology
Sound Setting
Double Action encoder
IMPRINT
/ENTER
PRESET
Rotary encoder
SOUND
/ENTER
PRESET