Filter
Top Products
30
CH1
CH2
CH3
CH4
SENSITIVITY
MOTION SETTING
MAIN PAGE
: ON
: OFF
: OFF
: OFF
: 3
RECORD
ALARM / MOTION
TIMER/ SEQ/ TITLE
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO CLOCK/ TIMER PAGE
RECORD
ALARM / MOTION
TIMER/ SEQ/ TITLE
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO CLOCK/ TIMER PAGE
closes in case of activation.
NC: Normally Closed. This is to be used with
the type of alarm sensor whose contact
remains closed in normal conditions and
opens in case of activation.
ALM DURATION:
This option allows users to set alarms for a
certain duration. You can select one of the six
following options: 0 SEC, 30SEC, 1 MIN, 5
MIN, 10 MIN, and NON-STOP.
NOTE: Recording may be interrupted during
Alarm-in or Alarm-out.
PRE- ALARM:
This option determines that images prior to an
alarm occurs will be recorded in the hard-disk
drive. When an alarm is triggered the device
will record the image prior to the alarm for 5
seconds (
10 frame / sec).
ON: Enables this function.
OFF: Disables this function.
NOTE: If the device is already under recording
mode before an alarm occurs, the
pre-alarm recording will not take effect.
MOTION SETTING:
The motion detection function is convenient for
people without an alarm trigger input, but the
function can be used with an alarm trigger
input at the same time. If this function is
enabled, the object movement will trigger the
alarm recording just like the outside trigger
signal. Before using the motion detection
function, please turn the CH1/ CH2/ CH3/ CH4
options at ON, and set SENTIVITY (1 ~ 5) to a
suitable value.
CH1/ CH2/ CH3/ CH4 :
These options enable/disable the motion
detection.
ON: Enables the motion detection.
OFF: Disables the motion detection.
SENSITIVITY(1 ~ 5):
This option allows users to set the motion
sensitivity. 1 is the most sensitive setting. 5 is
the least sensitive setting.
4.3 TIMER / SEQ / TITLE Setting
The DVR provides a weekly table consisting of
two periods of time each day for scheduled
recording. This option allows you to set the
time each day when the DVR will start and stop
recording.