Approach Tech NVR-2018 DVR User Manual


 
16
4. BASIC OPERATIONS
This section shows you how to operate and manage the NVR when it gets in the way.
4.1 Configuring Recording Settings
Recording Time settings (Image Resolution and Image Quality Setting)
Recording time will vary depending on the image size, quality, and the capacity of the hard-disk drives.
Generally, the NVR comes with a built-in hard-disk drive for continuous recording under most recording
conditions. The table below shows the possible recording times based on a 20GB hard-disk drive at
certain refresh rates and the corresponding image quality. With one or more hard-disk drive(s) in
operation, please calculate the recording time using the table below in accordance with your requirement.
For example, if the unit is set to record images with
HIGHEST quality at a 352 X 240 resolution, and
normally a 20GB hard-disk drive will be filled in 13 hours (See the gray area in the table). If the total
capacity of 80GB hard-disk drives is in use under the same refresh rate, image resolution and image
quality, it will be filled in 52 hours (4 times the rate of a 20GB hard-disk drive).
( 352 X 240 )
Audio OFF Possible Recording Time HDD=20GB ( hour )
HIGHEST 13 19 37
HIGH 18 25 52
MEDIUM 24 32 66
LOW 29 44 81
Image
Quality
LOWEST
43 66 137
R
efresh Rate ( Image/Sec ) 30 20 10
R
EC Time Mode 2 hr 4 hr 6 hr
( 720 X 480 )
Audio OFF Possible Recording Time HDD=20GB ( hour )
HIGHEST 11 18
HIGH 13 24
MEDIUM 17 31
LOW 23 48
Image
Quality
LOWEST
39 76
R
efresh Rate ( Image/Sec ) 30 20 10
R
EC Time Mode 2 hr 4 hr 6 hr
NOTE: Recording times on the tables above are estimated. For actual available recording
time of a recording configuration, please refer to the system information of the NVR.
(Please refer to section 3.3 system information for more details.)