Filter
Top Products
71
NOTE: This function can only work if the LAN which the unit is connected to has a DHCP
server. If the DHCP server is working, the NVR will obtain an IP address automatically
from the DHCP server. In that case please skip the section 11.2.2 (Set IP address) and
follow section 3. (TCP/IP Communication Software).
11.2.2 Set IP Address
You don’t need to set a NET IP for the unit if the LAN which the unit is connected to has a
DHCP server. Otherwise, please follow the instructions given below:
Use the
“^” and “v” buttons , and , to highlight the NET IP. Press the Enter button to
enter the NET IP page
Set the IP, MASK and GATEWAY. Then press the Enter button to proceed. The following
is a sample setting.
IP: 192.168.0.1
MASK: 255.255.255.0
GATEWAY: 0.0.0.0
NOTE: When only one unit of the NVR is connected to a computer or LAN, you can freely
assign an IP address for the NVR. For example, there is a range of NVR IP
addresses from 192.168.0.1 to 192.168.0.255. You can pick one for use from the
range of the IP. It’s not necessary to set MASK and GATEWAY; leave the settings
as default.
When a NVR is connected to a WAN, you must acquire a unique, permanent IP
address and correctly configure the MASK and GATEWAY settings according to
your network architecture. If you have any questions regarding those settings,
please contact a qualified MIS professional or your ISP.
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
NET IP : SET
NET DHCP : OFF
LEASED IP TABLE : ENTER
IP POOL RANGE : SET
COMM ID : 01
RS232 : ON
MAIN PAGE
SET NETWORK