Filter
Top Products
Chapter 4. Firmware Upgrade
31
Firmware Upgrade Recovery
There are basically three conditions that call for firmware upgrade recovery:
When the unit’s firmware becomes corrupted for some reason and you are
unable to operate it.
When a firmware upgrade procedure is interrupted.
When a firmware upgrade procedure fails.
To perform a firmware upgrade recovery, do the following:
1. Slide the Firmware Upgrade Recovery Switch (see page 7) to the Recover
position.
2. Power off and restart the KL1100 according to the instructions given in the
Powering Off and Restarting section (see page 21).
3. Slide the Firmware Upgrade Recovery Switch back to the Normal
position.
4. Repeat Step 2.
Exiting Firmware Upgrade Mode
To exit the Firmware Upgrade Mode, do the following:
1. Slide the Firmware Upgrade Recovery Switch (see page 7) to the Normal
position.
2. Power off and restart the KL1100 according to the instructions given in the
Powering Off and Restarting section (see page 21).
kl1100.book Page 31 Friday, October 29, 2010 2:54 PM