Filter
Top Products
13
Chapter 4
RS-232 Commands
Overview
In order to use the RS-232 serial interface to attach a high-end controller (such
as a PC) to the VS1814T / VS1818T, use a serial cable such as a modem cable.
The end connecting to the VS1814T / VS1818T should have a 9-pin male
connector. Connect this to the serial interface on the rear of the VS1814T /
VS1818T. Refer to number 4 on the diagram on page 12.
Note: To configure the controller serial port, see page 10.
RS-232 Serial Interface
The VS1814T / VS1818T’s built-in bi-directional RS-232 serial interface
allows system control through a high-end controller, PC, and/or home
automation / home theater software package.
Configuring the Serial Port
The controller’s serial port should be configured as follows:
Baud Rate 19200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None