Audiovox 3200 DVD Player User Manual


 
Installation-DVD3200
This unit is designed for installation in vehicle cabs with an existing radio opening. In many
cases, a special installation kit will be required to mount the DVD3200 to the dashboard.
These kits are available at electronics supply stores and car stereo specialist shops. Always
check the kit application before purchasing to make sure the kit works with your vehicle.
:
1)
2)
3)
4)
5)
6)
MUST
Universal Installation Procedure Using DIN Mounting Sleeves
Slide the mounting sleeve off of the chassis. If it is locked into position, remove the end caps and
use the removal tools (supplied) to disengage it.
Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large
enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Do not
force the sleeve into the opening or cause it to bend or bow. Check that there is sufficient space
behind the dashboard for the DVD player chassis. Wire prior to actually installing the sleeve. (See
Figure 10 on page 15) Wiring the DIN power harness assembly should take place after hole size is
confirmed. Mount sleeve after wiring.
Locate the series of bend tabs along the top, bottom, and sides of mounting sleeve. With the sleeve
fully inserted into the dash opening, bend as many tabs as necessary so that the sleeve is firmly
secured to the dashboard.
Follow the wiring diagram carefully, (See Figure 10 on page 15) and make certain all connections
of the wiring harness are properly secured and insulated to ensure proper operation of this unit.
After completing the wiring connections, turn the unit on to confirm operation (ignition switch must
be “ON”). If unit does not operate, recheck all wiring until problem is corrected. Once proper
operation is achieved, turn off ignition switch and proceed with final mounting of the chassis.
Carefully slide the DVD player into the mounting sleeve, making sure it is right-side-up until fully
seated, and that the spring clips lock it into place.
Attach one end of the DIN mounting strap (supplied) to the screw stud on the rear chassis using the
flange nut provided (See Figure 2 on page 6). Fasten the other end of the DIN mounting strap to a
secure part of the dashboard, either above or below the DVD player using the screw and flange nut
provided. Bend strap to position as necessary.
The rear of the DVD player be supported with the strap to prevent damage to the
dashboard from the weight of the DVD player or improper operation due to vehicle vibration.
CAUTION:
Figure 1
5