Filter
Top Products
I. Watching TV
1. Refer to Figure 2. From the factory the antenna jack of the built-in foil
dipole has already been connected to the antenna terminal
behind the door in the rear of the console. For connecting an external an-
tenna open the access panel on the rear of the console, and loosen the nut
around the antenna jack, unplug the antenna jack, and connect the coaxial
cable of an external antenna to the antenna terminal. In addition to normal
broadcast reception of VHF and UHF channels, you can connect the CATV
cable directly to the antenna terminal for CH1 ~ CH125 reception. Reattach
the access panel to the console, having the cable pass though either hole at
the bottom.
2. With power applied to the system, press POWER to turn the unit on. (Or
press POWER on the remote control to turn the unit on.
3. Select the TV mode by pressing TV/AV on the front of the unit (or TV/DVD on
the remote control).
4. VOLUME/PICTURE SELECTOR UP/DOWN BUTTONS. Use these buttons
to raise (
) or lower ( ) the sound level also used to make picture
adjustments in the picture select mode.
5. PICTURE SELECTION BUTTON. Each time this button is pressed, the on
screen picture adjustment display cycles through “adjustment bars for CON-
TRAST, BRIGHTNESS, COLOR and TINT. Then use VOLUME UP/DOWN
buttons to raise ( ) or lower ( ) the level. This display will automatically
turn off it no adjustments are made within about 6 seconds, or if any other
button is depressed.
6. MUTE BUTTON. Press the button to cut off all sound. Pressing the button
again restores sound to the previously set level. MUTE may also be re-
leased by pressing the VOLUME UP/DOWN BUTTONS.
7. AUTO PROGRAM BUTTON. When AUTO PROGRAM button is depressed,
all channels in TV or CATV mode are searched and tuned and the channels
with signals detected are automatically stored.
9. SKIP/SEARCH BUTTON. This button selects between SKIP and SEARCH
mode. In “SKIP mode” the TV only stops on channels that are programmed
into memory when the CHANNEL UP/DOWN buttons are used. When SKIP
mode is off, the TV will stop on all active channels.
10. Press (TV) DISPLAY to illuminate the on-screen display for TV
channel number.
11. Press SLEEP to set the remaining playing time.
20