Filter
Top Products
1. Temporarily place the cardboard mounting template in the appropriate mount-
ing location on the floor between driver/passenger seats, with the four hole
end of the template facing the front of your vehicle. Be sure to leave enough
space for the disc tray to fully open. Make sure that you have checked un-
derneath the vehicle and within the vehicle (under the carpet) for obstruc-
tions. Mark the mounting hole locations.
2. Drill 6 small 1/8” pilot holes though the marks and verify that the holes are in
the proper locations on the floor. After verifying that the 1/8” pilot holes are in
the proper locations, use the 1/4” drill bit to enlarge the pilot holes.
3. Place the mounting plate on the floor over the 4 holes close to the front of the
vehicle, with the tongue end of the plate facing the rear of the vehicle. Place
4 floor bolts through the mounting plate and into the holes just drilled. Under
the vehicle place 1 sealing washer (rubber side towards vehicle floor) and 1
large fender washer over each of the bolts and attach the nuts. In addition to
the sealing washer it may be desirable to place a small circle of silicon sealer
around the hole under the vehicle before installing the washers and nut. This
will further prevent moisture from getting into the vehicle. Have a second
person inside the vehicle hold the floor bolts securely with a box-end wrench
while the person underneath the vehicle tightens down the nuts securely.
4. Set the console on the mounting plate, with the slot of the console base
pointing to the tongue end of the mounting plate. Push forward to mate the
console base and the floor mounting plate, with the tongue of the mounting
plate projecting into the slot of the console base.
5. Place 2 bolts through the 2 holes in the front base of the console and into the
2 holes through the vertical floor. Under the vehicle place 1 sealing washer
(rubber side towards vehicle floor) and 1 large fender washer over each of the
bolts and attach the nuts. In addition to the sealing washer it may be desir-
able to place a small circle of silicon sealer around the hole under the vehicle
before installing the washers and nut. This will further prevent moisture from
getting into the vehicle. Have a second person inside the vehicle hold the
bolts securely with a box-end wrench while the person underneath the ve-
hicle tightens down the nuts securely.
5