Filter
Top Products
52
AM/FM Radio Operation
Band (AM/FM)
Repeatedly press the BAND button on the remote control to change between the FM and AM
bands as follows:
• FM1 / FM2 / FM3 / AM1 / AM2
Each band can store 30 stations.
OSD ON/OFF
• When the changer is connected, the OSD for changer information will be shown in
AV2 mode. Press the BAND button, and the OSD of the changer information will be
"ON" or "OFF".
Seek (Manual) UP/DOWN
The Seek Up/Down feature allows the user to manually tune to a radio station. Press and hold
the SEEK button for 2 seconds to access the Seek Mode. To use this button for Manual Tuning,
press this button for 2 seconds and then tune the frequency by channel spacing. If a button is
not pressed for 5 seconds, the mode will change back to SEEK mode.
• Memory: In order to memorize the station as tuned manually, first press the SEEK
UP/DOWN buttons and press and hold this button after finding the station. Then, the
desired station should be memorized.
Preset Radio Station SCAN
(P.S/BSM button on the display or P.SCAN button on the remote control.)
With the Preset Scan feature, the unit will scan the desired band for tunable stations. First,
select the desired band (FM1/FM2/FM3/AM1/AM2) and press the PS/BSM button for 2 seconds.
The tuner will then search until a station of sufficient signal strength has been found. The unit
will store 30 stations in the band automatically starting at the strongest signal strength.
Press this button quickly and stations will be automatically stored. When seeking for a desired
station, press this button once, and the Tuner will stop at the station.
Stored Radio Station Deletion
Locate the radio station as shown on the monitor by using the direction buttons (
,
,
,
).
•
Delete:
First select a stored station to be deleted as shown on the display. Then
press the DELETE button to erase it from stored memory.