Filter
Top Products
11
When you are in full screen preview, press the following buttons on the remote
control and control panel to switch to different channel, or preview all 4 channels:
CH1: Camera 1
CH2: Camera 2
CH3: Camera 3
CH4: Camera 4
QUAD:
4-Channel
2.3 Playback the Video
If the unit is recording the video, you may have to stop video recording in order to
do video playback. To stop video recording, press .
2.3.1 To Playback Video
1. Press .
2. Use the and or and
buttons to go up and down and select
TIME SEARCH or EVENT LIST. Then, press
or to make a selection.
SEARCH METHOD
TIME SEARCH
EVENT LIST
TIME SEARCH (search by date and time):
1. In the selected HARD DISK, press or
. Then, use the and or
and buttons to select MASTER or
SLAVE. Press or again to make the
selection. The START TIME and END TIME show
the date and time from when the recording begins
and end.
MASTER
TIME SEARCH
HARD DISK :
START TIME
END TIME : 2006 / 05 / 05 13 : 08 : 13
: 2006 / 05 / 04 10 : 00 : 01
: 2006 / 05 / 04 10 : 00 : 01SEARCH TIME
2. Use the and or and buttons and select SEARCH TIME.
Then press or again to make the selection.
3. In the SEARCH TIME, you may now select the date and time from where you want to begin
the video playback. Use the and or and buttons to move the selection
to the left and right. Use the and or and buttons to select the
date and time. Then press or again to make the selection.
4. To start video playback, the time in second must be set. Use the or buttons to
move the selection to the left most. Use the and or and
buttons and select the time in second. Then press or .