Filter
Top Products
22
PGXG-61B/PGWX-61B/PGWU-61B - - 2015/04/01
3. Installation
3.4 Powering On/Off the Projector
Ensure that the power cord and signal cable are securely connected. Power on the switch 1. and the Status
LED is solid red.
Turn on the lamp by pressing “2. ” on the remote control. The Status LED is off.
The startup screen displays in approximately 10 seconds.
Turn on your source. Select an input source by the remote control 3.
(HDMI, VGA, BNC, DVI or Video).
The projector detects the source you selected and displays the image.
Power Switch
Power button
3.4.1 Powering On the Projector
Procedure:
Status LED
IR Receiver
Press “1. ” key of the remote, a message displays on the projector’s screen.
Press “2. ” key again to conrm, otherwise the message disappears after 5 seconds.
3.4.2 Powering Off the Projector
Procedure:
CAUTION: Don’t turn on the projector immediately after entering Standby mode.