Filter
Top Products
7
PGXG-61B/PGWX-61B/PGWU-61B - - 2015/04/01
1. Safety
Notice on safety
This equipment is built in accordance with the requirements of the international safety standards IEC60950-1,
EN60950-1, UL60950-1 and CAN/CSA C22.2 No.60950-1, which are the safety standards of information technol-
ogy equipment including electrical business equipment. These safety standards impose important requirements
on the use of safety critical components, materials and insulation, in order to protect the user or operator against
risk of electric shock and energy hazard and having access to live parts. Safety standards also impose limits to the
internal and external temperature rises, radiation levels, mechanical stability and strength, enclosure construction
and protection against the risk of re. Simulated single fault condition testing ensures the safety of the equipment to
the user even when the equipment’s normal operation fails.
Users denition
Throughout this manual, the term SERVICE PERSONNEL refers to persons having appropriate technical training
and experience necessary to be knowledgeable of potential hazards to which they are exposed (including, but not
limited to HIGH VOLTAGE ELECTRIC and ELECTRONIC CIRCUITRY and HIGH BRIGHTNESS PROJECTORS) in
performing a task, and of measures to minimize the potential risk to themselves or other persons. The term USER
and OPERATOR refers to any person other than SERVICE PER-SONNEL, AUTHORIZED to operate professional
projection systems.
A PRESENT series projector is intended “FOR PROFESSIONAL USE ONLY” by AUTHORIZED PERSONNEL
familiar with potential hazards associated with high voltage, high intensity light beams, ultraviolet exposure and high
temperatures generated by the lamp and associated circuits. Only qualied SERVICE PERSONNEL, knowledge-
able of such risks, are allowed to perform service functions inside the product enclosure.
Owners record
The part number and serial number are printed on a label which is stuck on the respective part. Record these num-
bers in the spaces provided below. Refer to them whenever you call upon your Barco dealer regarding this product.
Product article number
Product serial number
Dealer
1.2 Important safety instructions
To prevent the risk of electrical shock
This product should be operated from a mono phase AC power source. y
This apparatus must be grounded (earthed) via the supplied 3 conductor AC power cable. If none of the sup- y
plied power cables are the correct one, consult your dealer. If you are unable to insert the plug into the outlet,
contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug.
Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord. y
To disconnect the cord, pull it out by the plug. Never pull the cord itself.
Use only the power cord supplied with your device. While appearing to be similar, other power cords have not y
been safety tested at the factory and may not be used to power the device. For a replacement power cord,
contact your dealer.
Do not operate the projector with a damaged cord. Replace the cord. Do not operate the projector if the projec- y
tor has been dropped or damaged until it has been examined and approved for operation by a qualied service
technician.
Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. y
If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should be y
used. A cord rated for less amperage than the projector may overheat.
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage y
points or short out parts that could result in a risk of re or electrical shock.
Do not expose this projector to rain or moisture. y
Do not look into the projector’s lens when the lamp is on. The bright light may hurt and
damage your eyes.