Filter
Top Products
15
SETUP
I
S06
0
P13
SELECT
BACK
SYSTEM
CHANNEL
FINE TUNE
SEARCH
PROGRAM NO
STORE
AUTOPROGRAM
COUNTRY SELECTION
BELGIUM
CZECH REP.
DANMARK
DEUTSCHLAND
ELLADA
ESPANA
FRANCE
HUNGARY
IRELAND
ITALIA
NETHERLANDS
NORGE
ÖSTERREICH
POLSKA
PORTUGAL
SCHWEIZ
SUOMI
SVERIGE
TÜRKİYE
U.K.
..........................
START AUTOPROGRAMMING
Note 2: The password for both of these
features has been set as 0000 at the factory.
You can change the password as you wish
under Change PIN item in the Access
Control menu.
6.3.6.3-User Interface Options
From this menu, you can decide whether
to display the scrambled channels in the
program table or not. If List Scrambled
Channels is set to ON, all channels will
be displayed, if it is set to OFF, scrambled
channels will not be displayed and if it is set
to AUTO and a CI card is installed to your
television, then the scrambled channels
supported by the card will be displayed.
6.3.6.4-Timers
In this menu you can view Reminders you
had entered from the EPG or change or
delete the entered Reminders.
6.3.6.5-Favourite Lists
Please see 6.3.3.2-Creating favorite channel
list for detailed explanation of this feature.
6.3.6.6-Common Interface Module
In this menu, you can make the CI Module
settings that you can attach to your
television.
6.3.6.7-System Menu
You can display your television’s hardware
and software data under this menu.
6.4-Performing Analog
Tunings
You can either tune the Analog channels
automatically or manually and store them in
your television.
6.4.1-Automatic tuning of channels
and storing in the memory
Note: If your television does not receive any
antenna broadcast for a period of 5 minutes,
it automatically switches to the stand-by
position. The countdown OSD is displayed
on the screen during the last 1 minute
(applicable for Analog mode only)
You can tune the programs automatically
with the Autoprogram function of your
television and then sort the channels as you
desire by means of the Program Table. Press
AV button on your remote control, select
ANALOG TV tab from the SOURCE menu
by using Up/Down movement buttons
and confirm by pressing the OK button.
Your TV will switch to Analog mode. Press
the MENU button on your remote control.
Select SETUP tab with Down movement
button and confirm with OK button. Setup
menu is displayed.
Select PROGRAM NO tab by pressing
the Up/Down movement buttons in Setup
menu, enter the channel number to be
searched and stored automatically, then
select AUTOPROGRAM tab by using the
Up/Down movement buttons and press
OK button; Country Selection menu will be
displayed.
In the Country Selection menu, select
the country, whose broadcast you would
like to watch in priority, by pressing the
right/left movement buttons and start
autoprogramming by pressing the OK
button. The channels will be automatically
searched and those found will be stored in
memory starting from the program selected
in the Setup menu. At the same moment,
the Autoprogram menu will be displayed
and a marker indicating the progress of the
autoprogramming will appear as shown
below.