Filter
Top Products
Using the projector 21
Using the projector
Start up
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energising the lamp.
4. If you are prompted for a password, press the arrow buttons to select the four
password digits, then press the AUTO button. For information about the password
function, refer to "Utilizing the password function" on page 22.
5. Switch all of the connected equipment on.
6. The current input source being scanned displays in the upper part of a dialog on the
screen. The scan will continue until signal from the input source is detected.
If the Auto Off function (See "Auto Off (Off)" on page 35 for details) is activated, the projector
will turn off automatically if no input signal is detected from the selected source after the
period of time as set by the Auto Off function.
1. Plug the power cord into the projector and
into a wall socket. Turn on the wall socket
switch (where fitted). Check that the
POWER indicator on the projector lights
orange after power has been applied.
2. Slide open the lens cover. If it is left closed,
it could become deformed due to heat.
3. Press and hold (for 2 seconds) the Power
button on the remote control or projector
to start the unit. The POWER indicator
light flashes green and stays green when the
unit is on.
The start up procedure takes about 30
seconds after pressing the Power button In
the later stage of start up, a default BenQ
logo is projected.