Bose 28 DVD Player User Manual


 
9
Capabilities and Controls
English
Play options
Note: All of the buttons shown below, except Shuffle and Repeat, can be used with your VCR or
DVR after the remote has been set to control it.
If the remote does not work as you expect
If your system does not respond when you press a button on the remote, it could be time to
change batteries. For information on the type of batteries to use and how to change them,
refer to “Troubleshooting” on page 41.
In some buildings, you may experience “dead spots” where the remote control will not
operate effectively. If this happens, move the remote a foot or two and try again. Also make
sure the cord that connects the power supply to the media center (and contains the remote
antenna) is stretched to its full length. If these efforts do not work, move the media center a
few feet to a location where it provides a better response.
If the batteries are fine and the suggestions concerning “dead spots” above do not work, you
may need an antenna extender. To contact Bose
®
customer service to request one, refer to
the address list included with the system.
Stops the disc player.
Note: For DVDs and VCDs only, the system remembers the point where the disc was
stopped. Pressing again clears that memory.
Pauses the disc player.
Starts the disc player.
Skip back or forward to the start of a track or chapter.
Or, when pressed and held, scans back or forward through the
current CD or MP3 disc, or adjusts the speed of the scan.
Plays CD tracks in random order. Press
Shuffle
again to cancel this mode.
Repeats a whole CD or track, DVD chapter, or DVD title. Press
Repeat
again
to cancel the repeat mode.