Filter
Top Products
13
English
Choosing connection types for your A/V devices
If you connected your TV to the VS-2 using an S-Video cable, you can use only an S-Video or Composite con-
nection for your A/V devices even though a device may have HDMI or component video output connectors.
1. Look at the rear panel of each A/V device to determine what type of video output connectors it has.
2. In the following table, choose the type of video connector that provides the highest possible video quality.
We recommend using an S-Video connection if it is available. Place a check mark in the table for the connec
-
tor type used for each of your A/V devices.
Connecting your A/V devices to the VS-2
1. Plug one end of the video cable into the appropriate video output connector on the rear of your A/V
device.
2. Plug the other end of the video cable into the appropriate Video INPUT connector(s) on the VS-2.
3. Refer to your LIFESTYLE
®
system installation guide for information on making audio connections.
Video
Quality
Video
Connector VCR CBL•SAT
AUX
(Other)
Good S-Video
Standard Composite
DO NOT USE
DO NOT USE
DO NOT USE
VS-2
If any of your A/V devices do not have an S-Video connector, you can use a
Composite connector. Remember, the VS-2 converts this up to S-Video format.
00_LasikOG.book Page 13 Thursday, October 26, 2006 1:23 PM