Filter
Top Products
21
English
Maintaining Your VS-2
Cleaning
• Use only a soft, dry cloth to clean the outside of the VS-2.
• Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives.
• Do not allow liquids to spill into any openings.
• Do not use any sprays near the VS-2.
Troubleshooting
Problem What to do
System will not turn on • Make sure the VS-2 cable is correctly connected between the VS-2 and the media center (see “Connecting the VS-2 to your media
center” on page 6).
• Make sure the media center power supply is plugged into an AC receptacle.
No picture on TV • If you have not done so, load the software update disc into the DVD player. See “Updating the system software” on page 17.
• Make sure the VS-2 cable is correctly connected between the VS-2 and the media center (see “Connecting the VS-2 to your media
center” on page 6).
• Make sure you connected your TV to the TV output connector on the VS-2.
• Make sure you have selected the correct video input on your TV.
The wrong picture appears
on my TV for the source I
selected
• If you have not done so, load the software update disc into the DVD player. See “Updating the system software” on page 17.
• Make sure your sources are connected to the appropriate VS-2 inputs.
• Make sure the Serial Data plug from the VS-2 is fully inserted into the media center connector.
• Make sure you have selected the correct video input on your TV.
Some sources do not
appear on my TV
• Make sure your sources are connected to the appropriate VS-2 inputs.
• Make sure you have not used a source that outputs a video format that is higher in quality than what your TV can accept.
00_LasikOG.book Page 21 Thursday, October 26, 2006 1:23 PM