Filter
Top Products
Page 11SKU 66508 For technical questions, please call 1-800-444-3353
Switch (5) in the NORMAL position, whether feeding the Cable into the drain pipe, or
pulling it out. Use Reverse position only to release the Cable if it should become caught
in the drain pipe line, and only for a few seconds.
When the job is complete, unplug the Power Cord from the electrical outlet and coil 12.
it. Store the Drain Cleaner and cutter tools in clean and dry location.
OPERATING TIPS
When Cable starts
to bend, twist or
whip.
Too much slack in Cable or cutter tool caught in stoppage. Re-
lease Foot Pedal, press Direction Lever down to temporarily re-
verse cable feed direction, and re-wind to relieve twist on Cable.
Pull Direction Lever up (FORWARD) to continue.
When Cable has
trouble getting
around tight bends
in drain pipe.
Press Motor Direction Switch (5) to Reverse while applying
steady pressure to Cable. Keep in mind that this will reverse auto
feed operation as well. Do for only a few seconds to pass bend.
More time could cause tangling or kinks in the Drum. If problem
persists, Cable is too large for pipe. Switch to a drain cleaner with
a smaller cable.
When Cable reach-
es clog in drain pipe.
Do not force Cable through stoppage. Press Direction Lever to
neutral position. Allow Cable to progress forward slowly, chew-
ing stoppage. Slow forward movement reduces stress on Cable,
while cleaning better. Try back and forth Cable movement, using
the Direction Lever (44-16).
TROUBLESHOOTING
Problem Probable Cause(s) Solution(s)
Motor cuts off
during use.
The motor may have been shut
off by it’s internal thermal protec-
tion switch, or auto reset breaker.
Turn motor off. Allow motor to cool
off completely before restarting and
stay clear of cable when turning
motor back on.
Cable kinks,
twists, or breaks.
Too much force on the cable. 1.
Too much slack between Drain 2.
Cleaner and drainpipe inlet.
Cable used is wrong size for 3.
drain pipe.
Cable exposed to acid.4.
Cable worn out.5.
Do not force cable. Let cutter 1.
tool do the work.
Move Drain Cleaner to within 2.
two feet of drainpipe inlet.
Change cable size. 3.
Clean and oil cable regularly.4.
Replace cable5.
Cable tangles in
drum.
Too much force on the cable. 1.
Motor running in reverse. 2.
Distributor tube frozen.3.
Do not force cable. Let cutter 1.
tool do the work.
Retract Cable with the Motor Di-2.
rection Switch (5) in the Forward
position.
Lubricate distributor tube bear-3.
ings.