Filter
Top Products
Page 14SKU 66508 For technical questions, please call 1-800-444-3353
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE
PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
While the Case is open, thoroughly clean and oil all parts and then reassemble in 5.
reverse order.
Guide Roller Replacement
Guide Rollers (44-9) due to excessive use may be damaged to a point of failure and
need replacement. Replace all three Guide Rollers at the same time.
Tangled Cable
If the Cable loops over itself in the Drum, it will not feed properly. With the motor stopped
and cord unplugged, remove and reload the Cable by hand to restore proper functioning. If
the Cable kinks, it is evidence of abuse and results from the use of too much pressure when
drain cleaning, or use of the wrong size Cable for the drain pipe being cleaned. Do not force
the Cable during use, let the cutter tool do the work.
Removing a Stuck Cable in the Drain Pipe
If the cable gets caught in the drain pipe move the Motor Direction Switch (5) to the Off 1.
position. Then, once the drum has stopped turning, move the Motor Direction Switch
(5) to the Reverse position to free the Cable.
If using the Power Cable Feed, putting the Motor in reverse will cause the feed Direc-2.
tion Lever (44-16) to operate opposite of normal.
Press the Pneumatic Foot Pedal (14A) while pulling on the Cable.3.
After the Cable is loose, move the Motor Direction Switch (5) back to the Forward 4.
position.
Caution: Running the Motor in reverse for more than a few seconds at a time can
cause the Cable to tangle in the Drum.
REV 09b