Filter
Top Products
Page 6SKU 66508 For technical questions, please call 1-800-444-3353
The grounding prong in the plug is con-2.
nected through the green wire inside
the cord to the grounding system in the
tool. The green wire in the cord must
be the only wire connected to the tool’s
grounding system and must never be
attached to an electrically “live” termi-
nal. (See 3-Prong Plug and Outlet.)
The tool must be plugged into an ap-3.
propriate outlet, properly installed and
grounded in accordance with all codes
and ordinances. The plug and outlet
should look like those in the preceding
illustration. (See 3-Prong Plug and
Outlet.)
Double Insulated Tools: Tools with
Two Prong Plugs
Tools marked “Double Insulated” do 4.
not require grounding. They have a
special double insulation system which
satises OSHA requirements and com-
plies with the applicable standards of
Underwriters Laboratories, Inc., the
Canadian Standard Association, and
the National Electrical Code. (See
Outlets for 2-Prong Plug.)
Double insulated tools may be used in 5.
either of the 120 volt outlets shown in
the preceding illustration. (See Outlets
for 2-Prong Plug.)
6.
Ground Fault Circuit Interrupter
(GFCI)
A Ground Fault Circuit Interrupter
(GFCI) is manufactured within the Power Cord
(15), about midway, due to the risk of electrical
shock when operating the Drain Cleaner, and
its proximity to water and ground. The GFCI
provides additional protection from the risk of
electrical shock.
Make sure that the Motor Direction 1.
Switch is in the Off position before plug-
ging in the Drain Cleaner.
Plug the GFCI Power Plug into a 2.
grounded, 120 VAC electrical outlet.
Press the TEST button, then press the 3.
RESET button. The GFCI indicator
should show Red in the window.
If the indicator is not red, try plugging
the Power Cord into a different electri-
cal outlet and repeat the steps. If the
same results occur, have the Power
Cord inspected by a licensed electri-
cian. Repair or replacement must be
completed by a licensed electrician.
Note: The Power Cord is not GFCI protected
from the GFCI unit to the 3-prong plug
in the electrical outlet.
EXTENSION CORDS
Grounded1. tools require a three wire
extension cord. Double Insulated
tools can use either a two or three wire
extension cord.
As the distance from the supply outlet 2.
increases, you must use a heavier
gauge extension cord. Using exten-
sion cords with inadequately sized
wire causes a serious drop in voltage,