Filter
Top Products
MSP-DARKWE/CE/CD/PZ-110 Installation Instructions
10
CABLE MANAGEMENT
NOTE: Steps 1 through 6 below apply to models
DARKWE110, DARKCE110 and DARKPZ110.
Proceed to Step 5 if installing DARKCD110.
1. Attach all cables to display.
2. Open the cable management bracket by sliding it towards
the edge of the arm (See Figure 9).
NOTE: If necessary, cable management bracket attach screws
may be loosened using hex key.
Figure 9
CAUTION: Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched
when bracket is closed.
3. Carefully insert cables into bracket (See Figure 10).
Figure 10
4. Close cable management bracket by sliding it back towards
the center line of the arm (See Figure 9).
NOTE: If necessary, cable management bracket attach screws
may be tightened using hex key.
CAUTION: Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of cover (H) or screws (J).
5. Carefully insert cables in cavity located in lower portion of
mount arm (See Figure 11).
6. Using Phillips screwdriver, install two covers (H) with four
screws (J).
Figure 11
OPEN Position
CLOSED Position
View from Bottom
Attach
Screws
2
4
Cable Path (typical)
NOTE: Display not shown for clarity.
Cable Management
Bracket (in open position)
3
Cable Path
(typical)
6
(J) x4
(H) x2
5