Filter
Top Products
MSP-DARKWE/CE/CD/PZ-110 Installation Instructions
8
To Desk (MSP-DARKCE110, MSP-DARKCD110)
1. Determine approximate location for mount keeping in mind
display size, arm extension, and pitch/roll requirements.
2. Using mount (B) as a template, mark location of three pilot
holes (See Figure 4).
3. Drill three 1/8” diameter pilot holes in mounting structure at
marked locations (See Figure 4). Ensure pilot holes are
straight.
Figure 4
IMPORTANT ! : IF you will be installing a display with
RECESSED mounting holes, then proceed to “DISPLAY
INSTALLATION” before continuing with this mount installation
procedure.
4. Install three #10 x 1 1/2” Phillips head screws (F) through
three #10 washers (G) and mount (B) into pilot holes (See
Figure 4). Tighten screws.
5. Proceed to “CABLE MANAGEMENT” if your display was
previously installed, or to “DISPLAY INSTALLATION” if your
display is not installed.
To Pole (MSP-DARKPZ110)
IMPORTANT ! : The following installation instructions
assume that a 1-1/2” NPT pipe has been properly
installed and is in place.
1. Determine approximate location for mount keeping in mind
display size, extension, height adjustment (if applicable),
and pitch/roll requirements.
IMPORTANT ! : IF you will be installing a display with
RECESSED mounting holes, then proceed to “DISPLAY
INSTALLATION” before continuing with this mount installation
procedure.
2. Place mount (V) against pole, with clamp (U) on opposite
side of pole (See Figure 5).
3. Using 5/32” hex key (Q), loosely assemble with three 1/4-20
x 1-1/4” button head cap screws (T). (See Figure 5)
Figure 5
NOTE: Equally tighten screws (T) against clamp (U) and mount
(V). (See Figure 6)
Figure 6
4. Position mount at desired height and orientation. Tighten
screws (T) securely.
5. Proceed to “CABLE MANAGEMENT” if your display was
previously installed, or to “DISPLAY INSTALLATION” if your
display is not installed.
DISPLAY INSTALLATION
NOTE: In Figures 7 and 8 the swing arm has been removed for
clarity.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the MSP-DARKWE110/-
DARKCE110 does not exceed 20 lbs (9 kg), MSP-
DARKCD110/MSP-DARKPZ110 - 25 lbs (11.3 kg).
1. Carefully place display face down on protective surface.
B
1/8” (3.2mm)
3
x3
2
x3
(F) x 3
4
(G) x 3
(V)
Pole
(U)
(T) x 3
3
Keep equal
distance between
mount and
clamp when
tightening
(T) x 3
(U)
(V)