Filter
Top Products
Installation Instructions MSP-DCCLCDS
6
Concrete Installation Instructions
(Option B)
Install the wall plate as follows:
WARNING:It is the responsibility of the installer to verify
that the structure to which the mount is
anchored will safely support five times the
combined load of all attached components and
equipment.
1. Determine a suitable mounting location and lift the wall
plate (10) into place (refer to “PARTS LIST” on page 3).
2. Draw a level plumb line to indicate the desired height of
the mount.
3. Hold the wall plate against the concrete wall making sure
the the mounting holes are level..
4. Drill four 5/16” holes into the concrete surface at the
marked locations.
5. Install the four 5/16” alligator toggle anchors (120) in the
holes.
6. Using four 5/16” lag bolts (80) and 5/16” washers (90),
secure the wall plate to the wall.
7. Slide the latches to the outside.