Filter
Top Products
7
Installation Instructions MSP-DCCLCDS
Steel Stud Installation Instructions
(Option C)
Install the wall plate as follows:
WARNING: It is the responsibility of the installer to verify
that the structure to which the mount is
anchored will safely support five times the
combined load of all attached components and
equipment.
1. Determine a suitable mounting location and lift the wall
plate (10) into place (refer to “WALL MOUNT PLATE
PARTS” on page 3).
2. Drill a 1/2” hole at the desired location, making sure wall
is at least 1/2” thick. If the wall is made with metal studs,
it is recommended to install the anchor through the dry-
wall and the metal stud (see Figure 4).
3. With plastic anchor (100) inserted in hole, slide finger grip
together to turn end inside hole perpendicular to wall
(see Figure 5).
4. Slide plastic ring of anchor to the surface of the wall
(see Figure 6).
5. Split finger grip ends apart to break of plastic ends flush
with plastic ring of anchor (see Figure 7).
6. Using the outermost mounting holes of the mount as a
template, repeat steps 1 through 5 for the remaining
anchors.
7. Using the 1/4-20 Phillips head screws (110 ) and flat
washers (50), secure the mount to the wall (see Figure 8).
Figure 5.
1/2” (1.27 cm) Min.
Thickness
Figure 6.
Figure 8.
Figure 4.
1/2” (1.27 cm)
Hole
BREAK OFF
PLASTIC ENDS
Figure 7.