Filter
Top Products
UCommand-616 Universal Remote Control User’s Manual
2 Quick Start
• This User’s Manual
If any of the above items are missing or appear damaged, contact your
dealer immediately. Do not throw the shipping carton away in case
you need to ship your UCommand-616.
Quick Start
If you are already familiar with the basics of teaching commands to
universal remote controls, you can skip reading the next few chapters
right now and get started on programming right away. The following
procedure applies to almost all functions of the UCommand-616.
For detailed Programming/Learning instructions, see page 26
To program the UCommand-616 to operate any Device :
1. Turn on the remote by pressing any hard button.
2. Press and hold the
menu
button until the Setup menu appears.
3. Scroll down to the Program item using the
CH+
and
CH-
buttons, and select it by pushing the
mute
button.
Pressing
menu
always returns you to the previous menu.
4. Select the Learning function from the Program menu.
5. Select the Device you want to learn.
6. Point the signal eye of your Device remote control at the
UC-616 Learning eye (bottom end of UC-616).
7. A screen appears showing the layout of the Direct Access
Buttons (also referred to as hard buttons) on the handle of
the UC-616. One button will look like a black dot. This is
the first button to be learned.
8. Press the corresponding button on your Device remote con-
trol, while keeping it aimed at the Learning eye. For example,
the first button to be learned on the UC-616 is the Hardware Access
Button
, which equates to your Device On/Off button.