Cub Cadet 5252 Flat Panel Television User Manual


 
29
ACCESSING THE ENGINE COMPARTMENT
WARNING: If the tractor has been
recently operated, engine surfaces will
be HOT. Allow the engine to cool
before opening the hood, or use
extreme caution to avoid burns when
the hood is open.
Locate the hood notch at the front of the tractor.
Depending on which type of hood latch is installed
on your tractor, raise the hood as follows:
Tractors with Latch Release Lever. Lift and
hold the latch release lever while lifting the
hood.
Tractors with Hood Latch Bracket. Pull the
hood latch bracket forward/upward to release
the front of hood; then lift hood. See Figure 33.
Figure 33
GENERAL BATTERY INFORMATION
WARNING:
Battery posts, terminals and related accesso-
ries contain lead and lead compounds. Wash
hands after handling.
Should battery acid accidentally splatter into
the eyes or onto the skin, rinse the affected
area immediately with clean cold water. If there
is any further discomfort, seek prompt medical
attention.
If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of
ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery charger
clips to the battery while the charger is turned
on, as it can cause sparks.
Keep all sources of ignition (cigarettes,
matches, lighters) away from the battery. The
hydrogen gas generated during charging can
be combustible.
As a further precaution, only charge the battery
in a well ventilated area.
Always shield eyes and protect skin and
clothing when working near batteries.
WARNING: Batteries contain sulfuric
acid and may emit explosive gases.
Use extreme caution when handling
batteries. Keep batteries out of the
reach of children.
BATTERY REMOVAL
WARNING: Battery posts, terminals
and related accessories contain lead
and lead compounds. Wash hands
after handling.
The battery is located at the front of the tractor
beneath the hood.
To remove the battery:
Open the tractor hood as described in the
previous sub-section.
Remove the two wing nuts and the battery
holddown strap from the battery holddown rods.
See Figure 34.
Figure 34
Spread the locking clips on the sides of the
terminal covers and lift the tops of the covers to
expose the battery connections. See Figure 34.
Lift Lever
Lift Hood
Hood
Latch
Pull Latch
to
Lift Hood
Latch
Release
Lever
Hood
Notch
BATTERY
HOLDDOWN
ROD
WING NUT
TERMINAL
COVER
HOLDDOWN STRAP
CABLE
CLAMP