Daewoo DDQ-9H1SC CRT Television User Manual


 
10
VIDEO/AUDIO CONNECTIONS
Prior to making any connections to your TV set, be sure to turn the POWER off.
For a more detailed understanding of each connection, it is recommended that you read the
instruction manual for each connected component.
If you use video or audio equipment placed near the Monitor/Receiver,picture and/or sound
may become distorted due to interference between these components.
In such a case,separate each piece of equipment at a sufficient distance.
The following shows examples for connecting external equipment.
Do not connect another audio source to the same speaker to which the TV set is connected,
otherwise damage may result to the amplifier of the TV set or to that of the other audio source.
AUDIO/VIDEO INPUT
1.Connect the VIDEO OUT jack from the VCR to the VIDEO IN jack on the TV.
2.Connect the AUDIO OUT jack from the VCR to the AUDIO IN jack on the TV.
3.Turn TV on and press VIDEO button on the Remote control to select VIDEO mode.
4.Turn the VCR on and Playback tape.(consult your VCR system's owner's manual.)
75 ohm
ANT
VIDEO AUDIO
TO VIDEO IN
TO VIDEO OUT
VCR or VDP
VHF/ UHF
OUTPUT
TO AUDIO IN
TO AUDIO OUT
9
CABLE TV(CATV) CONNECTION
A 75 ohm coaxial cable connector is built into the set for easy hookup.
When connecting the 75 ohm coaxial cable to the set, screw the 75 ohm cable to the
COAXIAL CABLE CONNECTOR.
Some cable TV companies offer "premium pay channels". Since the signals of these premium
pay channels are scrambled, a cable TV converter/descrambler is generally provided to the
subscriber by the cable TV company. This converter/descrambler is necessary for normal
viewing of the scrambled channels. (Place your TV on channel 3 or 4, typically one of these
channels is used. If this is unknown, consult your cable TV company. One possible method of
utilizing the converter/descrambler provided by your cable TV company is explained below.
"A" position on the RF switch (not supplied)
: You can view all unscrambled channels using the TV's channel keys.
"B" position on the RF switch (not supplied)
: You can view the scrambled channels via the converter/descrambler using the converter's
channel keys.
NOTE : RF switch equipped with position A/B(not provided) is required.
Cable TV line
TV
OUT IN
Cable TV converter/
descrambler
Two-set
signal
splitter
(not supplied)
RF switch (not supplied)
A
OUT IN
B