Filter
Top Products
PRO LOGIC SETTINGS
50
1.Press “MENU” button.
•The main menu will appear.
2.Select “Special”.
•Move the cursor to the “Special”, menu using
“VOLUMEC/B” buttons.
•Press “CHANNELx” button to select “Special”,
and the sub menu will appear.
3.Select “Pro Logic”.
•“Pro Logic” should be highlighted.
•Press “VOLUMEB” button to select “Pro Logic”.
4.Choose from the list.
•Press “VOLUMEC/B” buttons to choose one of the
“Pro Logic” modes.
NORMAL WIDE 3 STEREO OFF
•To adjust for a subwoofer:
Press “CHANNELx/y” buttons until the blue bar
indicates “Subwoofer”.
“VOLUMEC/B” buttons will turn the Subwoofer on
or off.
Move Sel. Exit
Picture
Pro Logic (
Tilt 32:32
DTV Off
Special
Move Sel. Prev.
Mode Normal
Subwoofer Off
Test Noise Off
Pro Logic
Move Sel. Prev.
Move Sel. Exit
Special
L “Pro Logic” mode
Normal:
This mode is used when the Center
speaker cannot easily and
accurately reproduce the low
frequencies. The bass from the
Center channel is reproduced by the
Left and Right (or Subwoofer).
This is the default mode for your
HDTV Monitor.
WIDE:
This mode is used when the Center
speaker is able to reproduce the low
frequencies.
3 STEREO:
This mode should be selected when
no Surround speakers are used. The
Surround channel information will be
reproduced by the Left and Right
speakers.
Manufactured under license from
Dolby Laboratories. “Dolby”, “Pro
Logic”, and the double D symbol
are trademarks of Dolby Laboratories.
L “Test Noise”
To hear a test tone that lets you hear
the volume of your surround sound
system, move the cursor to “Test
Noise”, and press the “VOLUMEB”
button. You will hear a test tone
between the left, center, right, and
rear surround speakers.
When you enable the noise
sequencer, it will continue in all
channels until you disable it.
For the best surround quality,
DAEWOO recommends that you
adjust the sound equally among
between all speakers. For example,
the volume of the front speakers
should match the volume of the rear
speakers.
Pro Logic Settings