Filter
Top Products
Setup Mode
10
• Exit Setup Mode by pressing and holding DONE until the Current
Weather screen displays.
Screen 1: Active Transmitters
Screen 1 displays the message “Receiving from...” and shows the transmit-
ters being received by the console. In addition, an “X” blinks in the lower
right-hand corner of the screen every time the console receives a data
packet from a station. The rest of the LCD screen is blank.
If you have a cabled station, or if your wireless ISS uses the factory set-
tings and you are receiving the signal, the screen displays “Receiving from
station No. 1”. Any optional stations that have been installed should also
display.
Screen 1: Active Transmitters
Note: An ISS or optional station must be powered for the console to recognize it. Refer to
the Integrated Sensor Suite Installation manual or optional station installation instruc-
tions for more information.
1. Make a note of the station number(s) listed on the screen.
2. Press DONE to move to the next screen.
The console can receive signals from up to eight transmitters total, but
there is also a limit on the number of certain types of transmitters. The
table below lists the maximum number for each type of transmitter:
Maximum Number of Transmitters
Note: Listening to more than one transmitter may reduce battery life significantly.
ST
A
TIO
N
N
O.
1
4
Transmitter Type Maximum Number
Integrated Sensor Suite (ISS) 1
Anemometer Transmitter Kit 1
Leaf & Soil Moisture/Temperature Station 2
Temperature Station 8
Temperature/Humidity Station 8