Filter
Top Products
Setup Mode
11
Screen 2: Configuring Transmitter IDs — Wireless Only
If you have a cabled station, press DONE and see “Screen 4: Time & Date”
on page 12.
Setup screen 2 allows you to change the ISS transmitter ID and to add or
remove optional transmitter stations. The default setting works fine for
most installations. The default transmitter ID setting is “1” (ISS).
Screen 2: Transmitter ID configuration
If you have a cabled station, or if you have a wireless station and are
using the default transmitter ID setting, press DONE to move to the next
screen.
Note: Typically, you can use the default transmitter ID setting of 1 unless you are installing
one of the optional transmitter stations or a nearby neighbor has a Vantage Pro2 Sta-
tion that uses transmitter ID 1 for the ISS.
3. Press the right and left arrows to select the transmitter ID.
When you select a transmitter ID, the ID number is displayed on the
screen as well as the current configuration.
4. Press the up or down arrows to toggle console reception of signals from
transmitters using that ID on and off.
5. Press GRAPH to change the type of station assigned to each transmitter
number. Scroll through the station types - ISS, TEMP, HUM, TEMP
HUM, WIND, RAIN, LEAF, SOIL, and LEAF/SOIL - until the correct
type appears.
6. Press DONE to move to the next screen.
Screen 3: Retransmit — Wireless Only
Press DONE and go to “Screen 4: Time & Date” on page 12 if you have a
cabled station.
The console can take data it receives from the ISS and transmit it to other
Vantage Pro2 consoles using the retransmit feature. By toggling the feature
1