Filter
Top Products
Troubleshooting Your TV Display 33
Poor picture quality when using a
device connected to the ANT/Cable
(coaxial) connector
1
Ensure TV display is selected as the input source in the
Input
Select
menu. See "Input Select Menu" on page 24 for more
information.
2
Press
Menu
on the remote control, select
Setup
, and then select
Channel Setup
. This resets the channels on your remote.
3
Check the aspect ratio settings in the OSD. Press the
Menu
button on the remote control and select
Size
. For more
information on using the OSD, see "Using the On-Screen
Display" on page 23.
4
Reset the original factory defaults. Press
Menu
on the remote
control, select
Setup
, and then select
Factory Reset
.
5
Adjust the color temperature. Press
Menu
on the remote
control, select
Picture
, and then select
Color Temperature
.
6
The problem may be with your device, contact your service
provider.
Nothing appears on my TV display 1
Ensure the TV display is turned on.
2
Verify that all the cables are properly connected to the TV
display, including the power cable.
3
Check to see if there is a blue or amber light on the lower,
right-hand corner of the TV display. A blue light indicates
the TV display is on. An amber light, means the TV display
is in power save mode.
4
Ensure the proper source is selected in the
Input Select
menu.
See "Input Select Menu" on page 24 for more information.
5
Reconnect any devices that are currently connected to the TV
display. If you are using multiple devices, connect and test one
device at a time.
6
Connect another device that you know is working properly.
7
Reset the original factory defaults. Press
Menu
on the remote
control, select
Setup
, and then select
Factory Reset
.
Problem Possible Solution