Filter
Top Products
QSD2014 User’s Manual
8
5.7 Record Schedule
Setting the Record Schedule allows you to customize the type of recording you want to use depending on
the time of day.
NO-RECORD [ WHITE ]:DVR will not record during this period.
NORMAL RECORD [ RED]:DVR will record continuously during this period.
SENSOR RECORD [ S ]:DVR will record when sensor or motion is triggered
Note: In order to activate the record schedule, please press [ REC] button to start Record schedule,
otherwise, DVR will not start recording.
5.8 Sensor Setup
CONT: Continuous alarm until any key is pressed…
OFF: No alarm
Note: Sensored Record Time and Alarm On Time are measured in seconds.
5.9 Motion Detector Setup
This section allows you to set up motion detection options for each camera.
The time line indicates 24 hours of a day based on
AM/PM (0=12).
Press [▲，▼，◄◄ and ►►] buttons to select a
time point, press [SEL] to modify the recording mode.
On/off
: Enable or disable motion detection
recording.
Level: Sensitivity for motion detection. There
are 3 levels of sensitivity: Level 1 to 3 with 3 the
highest.
Area: Select detectable area on the screen.
Record Schedule
AM PM
0… 3… 6… 9… 0… 3…. 6… 9…
NO-RECORD
NORMAL-RECORD
SENSOR -RECORD
( ) MOVE (SEL) SELECT (MENU) EXIT
S
Sensor Record Time indicates how long the
recording file remains open after the motion ends.
After this time the next alarm starts a new file.
Alarm on time indicates how long the buzzer
will sound when motion is detected.
SENSOR SETUP
SENSORED RECORD TIME 30
ALARM ON TIME 05
MOTION DETECTOR SETUP
( ) MOVE (SEL)SELECT (MENU)ESC
Motion Detector Setup
CH1 ON Level 2 Area
CH2 ON Level 2 Area
CH3 ON Level 2 Area
CH4 ON Level 2 Area
( ) MOVE (SEL)SELECT (MENU)ESC