Filter
Top Products
QSD2014 User’s Manual
9
Press “Stop” button to disable all areas, and press “Quad” button to select all areas.
5.10 Hard Drive Setup
HDD SIZE：indicates the total capacity of the hard drive installed in the DVR.
HDD USED：indicates the space used in the hard disk drive for recording and the percent used.
HDD FORMAT：will erase all video and data on the installed hard drive and make it readable by the DVR.
Note: You will be prompted for the password when formatting a hard drive and the default password is “111111”.
5.11 Miscellaneous Setup – Change Password
Area Selection
：
Press [▲，▼，◄◄ and ►►]
buttons to select a block and then press [SEL] button
to set the block to detect motion. The area is
detectable when it is clear, the area is not detectable
when it is covered by shadow.
OVERWRITE ENABLED
：
ON: System overwrites oldest files when hard drive
is full;
OFF: System stops recording when hard drive is full.
Hard Drive Setup
OVERWRITE ENABLED [ON]
MAXTOR STM250310AS
MASTER HDD SIZE 250203MB
MASTER HDD USED 124931MB 50%
MASTER HDD FORMAT
SLAVE HDD SIZE N/A
SLAVE HDD USED N/A
SLAVE HDD FORMAT
( ) MOVE (SEL)SELECT (MENU)EXIT
Enter the current password first, and then enter
six characters as your new password, repeat the new
password to confirm.
If you forget your password, please free feel to
contact Q-See tech support for assistance.
CURRENT PASSWORD
NEW PASSWORD
COMFIRM PASSWORD
[- - - - -]
[- - - - -]
[- - - - -]
This
option allows you to change the system
password. The password must be six characters. All
keys can be used as a
password key except the
[MENU] key, which is used to exit.
Miscellaneous Setup
CHANGE PASSWORD
SET TIME
HIDDEN CHANNEL
IMAGE PARAMETERS
PASSWORD ENABLE
KEYPAD TONES
SEQ. DWELL TIME
VIDEO LOSS SOUND
( ) MOVE (SEL)SELECT (MENU)EXIT
[OFF]
[ CH1 ]
[ OFF]
[ ON ]
[ 30 ]
[ ON ]